Connecting The Wireless Access Point To The Wireless Gateway; Pairing The Wireless Access Point And Receiver - Cisco ISB7105W Installation Manual

Connecting the Wireless Access Point to the Wireless
Gateway
1. Connect the 12 VDC Power Supply plug
on the access point to the wall power
outlet. Use only the power adapter
provided with the product.
2. Connect the power plug to the power
receptacle on the wireless access point.
3. Connect one end of the RJ-45 Ethernet
cable to the Ethernet port on the
wireless access point.
4. Connect the other end of the RJ-45
Ethernet cable to an available Ethernet port
on your wireless gateway.
1
2
3
4
5
6
Reset
1
CL
2
AP
Ethernet
3
12VDC
4

Pairing the Wireless Access Point and Receiver

1. Press the OK button on the receiver.
2. Press the WPS button on the wireless access point.
12
Reset
Ethernet
12VDC
1
2
3
4
5
6
Note: This illustration may vary from the actual product.
1 Reset
2 Mode Switch Converts the wireless access point to
3 Ethernet Port Connects the wireless access point to
4 Power
Note: This illustration may vary from the actual product.
RJ-45
Cable
CL
AP
To Wall
Power Outlet
Wireless LED
Wireless Link LED
Wi-Fi Protected Setup™ (WPS) button
Wi-Fi Protected Setup (WPS) LED
Ethernet LED
Power LED
Restores factory default settings when
held for more than 5 seconds
a wireless client
a receiver or wireless gateway
Connects device to the external
12 VDC power supply
Wireless
Gateway
Ethernet Port
12VDC
Power
Receptacle