Motorola BCM2046 Quick Start Manual

SYMBOL MT2000 Series
Quick Start Guide
http://www.motorola.com/mt2070
MT20X0 Poster MT20X0 Poster
http://www.motorola.com/mt2090
BLACK
PANTONE 285
DRAFT
1
Cradle Cable Connections
MT20X0 Cable Connection
NOTE: Cables may vary depending on configuration. When using an external power supply, insert the
cable into the cradle first, then insert host cable. Connect power last.
Please refer to the Symbol MT20X0 Product Reference Guide Troubleshooting section for further information.
Scanner not working
No power to scanner
Check battery
Scanner decoding bar code, but data not transmitting to host
Scanner not paired to host-connected cradle
Pair the scanner to the cradle (using the
PAIR bar code on the cradle)
RS-232 Host Types
STANDARD RS-232
NIXDORF RS-232 MODE B
NIXDORF RS-232 MODE A
USB Host Types
HID KEYBOARD EMULATION
See Product Reference Guide for more information
1
2
3
4
5
6
7
BATTERY INSERTION
2
CONNECTIONS
RS-232
Host
Power
USB
TROUBLESHOOTING
End cap not secured correctly
Turn end cap to secure
Cradle not programmed for correct host interface Interface cable is loose
Check scanner host parameters or Check for loose cable
edit options connections
If data is still not transmitting to host, it may be necessary to recycle power on the cradle.
SYMBOL MT20x0 PROGRAMMING BAR CODES
Host Types
Keyboard Wedge Host Types
IBM PC/AT and IBM PC COMPATIBLE
Radio Communications Host Types
ICL RS-232
CRADLE HOST
FUJITSU RS-232
BLUETOOTH KEYBOARD EMULATION (HID SLAVE)
OPOS/JPOS
IBM 46XX Host Types
PORT 5B
IBM HAND-HELD USB
Table Top Cradle Insertion
8
9
10
11
12
13
1 Left soft key
2 Tab - * key
3 Keypad
4 Orange key
5 Blue key
6 Battery
7 Tether Plate
8 LED Indicators
9 Scan Window
10 Navigation - ALT - CTRL key
11 Cold boot trigger
12 Enter key
13 Scan Trigger
BATTERY REMOVAL
1 2
HOST INTERFACES
Keyboard Wedge
or
IBM 46XX
or
Scanner not decoding bar code
Scanner not programmed Bar code unreadable
for bar code type
Ensure bar code is not defaced;
try scanning test bar code of same
Ensure scanner is programmed
bar code type
to read type of bar code being
scanned
Scanned data incorrectly displayed on host
Paired cradle host communication parameters do not match the host's parameters
Check cradle host parameters or edit options
Host Mode
CABLE PRIORITY
WIRELESS ONLY
Miscellaneous
Set Defaults
Note: The scanner connection to the cradle
is dissolved when Set Defaults is scanned.
SET DEFAULTS
SERIAL PORT PROFILE (SLAVE)
Unpairing/Disconnection
UNPAIR/DISCONNECT
Unpairing/Disconnection
SERIAL PORT PROFILE (MASTER)
UNPAIR/DISCONNECT
Scan to Add Prefix/Suffix Values
(Carriage Return/Line Feed)
SCAN OPTIONS
PORT 9B
ENTER
CABLE ONLY
<DATA><SUFFIX>