Advertisement
Available languages
Available languages
PADLOCK INSTALLATION INSTRUCTIONS FOR ALL UNITS
Figure 1
TOOLS REQUIRED- One wrench with 7/16" socket.
PADLOCK INFORMATION- Padlock with 7/8"–1" shackle
height (figure 3) (recommended Master No 5 or equivalent,
not included).
1. Open your padlock and slide the U-bolt over the
lock shackle.
2. Slide the lock through the lock housing on the front of
the box (figure 1).
TO INSTALL RAPID PASS
SIDE VIEW
Figure 5
"RapidPassThru"-1.eps
Figure 2
GROMMET (Model RB48 and Model RB60)
®
TOOLS REQUIRED- Hammer and flat blade screwdriver.
1. Locate the "knockout" on the upper right (facing box) corner of the rear
box panel.
2. With a screwdriver and hammer, carefully punch out the "knockout" from the
inside of the box so that metal ring will fall outside box (figure 4).
3. Place the rubber RAPID PASS
hole and be sure that it is properly seated. BE SURE NO SHARP METAL
EDGES ARE EXPOSED (figure 5).
4. When passing cords into the box, be sure to always enter box from the
rear. After head of cord is in place, slightly pull back 2-3" to ensure weather
resistant "star bursts" are facing toward the outside of box (figure 6). Never
Figure 4
push the cord from inside the box so that mating plug points are exposed to
the environment
5. BE SURE TO FOLLOW ALL ELECTRICAL SAFETY PRECAUTIONS.
U-Bolt
Lock Shackle
3. Guide the U-bolt through the two holes in the back of
the lock housing (figure 2).
4. Secure the U-bolt with the two nylon lock nuts supplied.
5. Repeat the procedure for the second lock.
6. To lock, close lid and push bottom of padlock until lock
"clicks" closed.
7. To open, turn key and open lid.
grommet from the inside of the box in the
®
2
7/8"-1"
Figure 3
(measure height
when lock is closed)
Figure 6
EXTERIOR
VIEW
Advertisement
