Daily Use - Washing & Drying - Electrolux EW9W7449S9 User Manual

32 www.electrolux.com
• If you have set
drains the water and spins.
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
12.15 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
13. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
13.1 Complete wash&dry
programmes
Automatic Non-Stop
programme
The appliance is equipped with the
NonStop programme, an automatic one-
go programme where it is not necessary
to set the Dry mode.
To run this programme:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Set the NonStop programme by
means of the programme dial.
The indicator
3. Touch the Start/Pause button to start
the programme.
, the appliance
, the appliance
or goes off,
flashes and then
appears on the display
• You do not use the appliance for 5
minutes before you touch the Start/
Pause button.
Press the On/Off button to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Wash and Dry mode for running
a complete wash&dry programme.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the Mode button once to
activate also the drying function. The
Wash and Dry indicators come on.