Advertisement
Quick Links
HOW TO INFLATE INNER TUBE
1. Locate the valve extender. Unscrew and
remove the black cap on the end.
2. Next, take your inner tube and locate the
valve stem. Unscrew and remove the black
cap on the end.
3. Connect and thread the valve extender
onto the inner tube valve stem.
4. Attach your air chuck to the opposite end
of the valve stem extender. The use of a
needle valve tool is recommended.
5. Now that everything is connected, inflate
the inner tube until full. When inflated,
the tube should measure approximately
20" high and five feet wide. Standard inner
tube inflation to~6 psi (40kpa).
6. Once the tube is filled the valve stem
extender can be removed and the
black cap can be threaded back onto the
valve stem.
7. Slide the tube down over the top of the
Monkey Jump pole assembly. Make sure
the valve on the inner tube is facing down
toward the ground.
MM00125
Valve Extender
Deflated Inner Tube
Inflated Inner Tube
Advertisement
Related Manuals for M&M MONKEY JUMP
Summary of Contents for M&M MONKEY JUMP
- Page 1 7. Slide the tube down over the top of the Monkey Jump pole assembly. Make sure the valve on the inner tube is facing down Inflated Inner Tube toward the ground.
- Page 2 WHAT TO DO IF INNER TUBE IS LEAKING AIR • If the Monkey Jump inner tube is losing air slow, check to ensure the needle valve inside the valve stem is properly tightened. • Replacement Monkey Jump inner tubes are available. Please contact M&M Sales Enterprises, Inc.