Table of Contents
Advertisement
Trouble shooting
en
Fitting the metal grease filter
Place the metal filter mat in the filter grille.
1.
Clamp the metal filter mat in place with the wires.
2.
Insert the filter grille.
3.
Make sure that the locks on the left and right
Note:
of the filter grille engage.
Changing the activated charcoal filter (only
in circulating-air mode)
In order to guarantee efficient odour filtration, the filter
must be serviced regularly.
The activated charcoal filters must be replaced at least
every 4 months.
Notes
The activated charcoal filters are not included in the
■
delivery. The activated charcoal filters can be
obtained from specialist retailers, from our after-
sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Only use genuine replacement filters. This
Note:
ensures optimal performance of the appliance.
Remove the fleece grease filter; see the section
1.
entitled
Removing the metal grease filter
Undo the threaded joints on the activated charcoal
2.
filter covers.
Remove the activated charcoal filter.
3.
Insert the new activated charcoal filter.
4.
Screw the covers into place.
5.
Install the metal grease filter; see the section entitled
6.
Installing the metal grease filter
8
.
.
3Trouble shooting
M alfunctions often have simple explanations. Please
T r o u b l e s h o o t i n g
read the following notes before calling the after-sales
service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Malfunction table
Problem
Possible cause
The appliance
The plug is not
does not work
plugged in.
Power cut
Faulty fuse
The lighting does
The bulbs are
not work.
faulty.
--------
Solution
Connect the appliance to the
electricity supply
Check whether other kitchen
appliances are working
Check in the fuse box to make
sure that the fuse for the appli-
ance is OK
For information on changing
the bulbs, see the "Replacing
Bulbs" section.
Advertisement
Table of Contents
