Installation Guide; Operation Guide - Black & Decker BWTD18TB Instruction Manual

SET UP & USE

INSTALLATION GUIDE

1. Unpack your wine cellar by removing all packaging materials like carton, base,
foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material used to hold shelves, ice tray,
etc. in place.
3. Clean the remains of all adhesive tap used and remove all printed material
supplied.
4. Install the wine cellar in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the wine cellar and side wall so the door(s)
will open without obstruction. Wine cellar is not designed for recessed or built-in
installation.
5. The floor on which the wine cellar should be placed must be flat, hard, solid, and
even. The wine cellar should not be placed on any soft material such as foam,
plastic, etc.
6. To level your wine cellar, use the two leveling legs in the rear and one in the front
left of your wine cellar. Adjust by turning the legs counter clockwise to raise or
clockwise to lower your wine cellar. The door will close easier if the leveling legs
are extended.
NOTE: The foot that is part of the door hinge bracket is not adjustable.
7. The following are recommended minimum clearances around the wine cellar for
proper air circulation:
Sides: 2" (50mm)
Top: 4" (100mm)
Back: 2" )50mm)
Proper air circulation will help your wine cellar work at maximum efficiency.
NOTE: · Allow enough space in the front of the unit to open door to at least 120˚.

OPERATION GUIDE

1. Plug in the wine cooler to power the unit on.
2. The temperature displayed will reflect the actual internal temperature of each zone.
3. Press the button to select the temperature display in Farenheit or Celsius.
4. Upper and bottom zone temperatures are each controlled separately.
5. Setting the operating temperature of your unit.
A. You may choose a temperature setting for the upper zone within the range of 45˚
to 53˚F. Set the temperature by pressing the upper zone button
the desired temperature is reached. Once selected, the temperature display will
revert to the actual temperature.
B. You may choose a temperature setting for the bottom zone within the range of 53˚
to 64˚F. Set the temperature by pressing the bottom zone button
until the desired temperature is reached. Once selected, the temperature display will
revert to the actual temperature.
6. Allow the wine cooler to operate empty for approximately one hour. This should allow
the unit to reach the desired temperature.
Page 6
repeatedly until
repeatedly