ABB HT581681 Operation Manual page 102

Turbocharger
Table of Contents

Advertisement

NOTICE
CAUTION
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Disassembling and assembling
turbocharger
If the compressor casing cannot be removed easily, it can be pressed
off using the press-off tool (90042) against the turbine casing. To do
this, the two cover plates (1, 2) must be removed from the hard insula-
tion on the turbine casing.
Axial force
The press-off tool can generate a high axial force and, if it is not used
properly (too much pressure on one side), it can damage the rotor.
It should thus be used alternately on both sides while avoiding ex-
cessive pressure on either side.
Loosen the screws (72011) and remove them together with the fas-
tening strips (72012).
Move the compressor casing (72000) with the wall insert (77000) care-
fully away, doing so horizontally.
Tap the wall insert (77000) out of the compressor casing using a nylon
hammer and remove the O-ring seal (77005).
TPS61 wall insert removal
Fasten lifting beam (90258) to wall insert.
Fasten swivel lifting eye (a) to lifting beam.
Remove wall insert (77000) using lifting gear.
Operation Manual / TPS48-D/E.. - TPS61-D/E..
8
8.3
Page 100

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tps 48e01

Table of Contents