Table of Contents
Advertisement
Problem
Poor baking results.
Appliance is not level.
Cannot move appliance easily.
Appliance must be accessible for
service.
Oven portion of appliance does not
operate.
Entire appliance does not operate.
Oven control panel beeps and displays
F code error (for example, F10).
Solutions to common problems •
Solution
• Allow oven to preheat to the set temperature before placing food in oven.
• Make sure the proper oven rack position is used.
• Center food in the oven and space pans to allow air to circulate.
• Try adjusting the recipe's recommended temperature or baking time.
• If you feel the oven is too hot or cool, see Adjusting oven
temperature in Setting Oven Controls section.
• Poor installation. To correct, place oven rack in center of oven. Place a
level on the oven rack. Adjust by turning leveling legs at base of
appliance until the oven rack is level.
• Be sure floor is level, strong & stable enough to adequately support the
appliance. If floor is sagging or sloping, contact a carpenter to correct the
situation.
• Kitchen cabinet alignment may make range appear not level. Be sure
cabinets are square & have sufficient room for appliance clearance.
• Cabinets not square or are built in too tightly to appliance sides. Contact
builder or installer to make appliance accessible.
• Carpet interferes with appliance. Provide sufficient space so appliance
may be lifted over carpet.
• Gas line is hard-plumbed. Have a flexible CSA International approved
metal appliance connector installed.
• Be sure gas valve on regulator is turned to ON position. See installation
instructions for more details.
• Be sure the oven controls are set properly for the desired cooking
feature. See "Setting Oven Controls" in this manual or see "Entire
appliance does not operate" in this checklist.
• The time of day is not set. The time of day must first be set in order to
properly operate the oven. See "Setting the clock" in "Setting oven
controls" section.
• Make sure power cord is plugged correctly into outlet.
• Service wiring is not complete. Contact your dealer, installing agent or
authorized service agent.
• Electrical power outage. Check house lights to be sure. Call your local
electric company for service.
• The oven control has detected a fault or error condition. Press cancel to
clear the display & stop beeping. Try the bake or broil feature again. If
the F code error repeats, remove electric power from appliance, wait 5
minutes and then repower appliance and set clock for the time of day.
Try the bake or broil feature again. If the fault recurs, record fault and
call your authorized service agent.
BEFORE YOU CALL
33
Advertisement
Table of Contents
