Pioneer RD-HWK100 Installation Manual

Hard Wire Kit
RD-HWK100
Installation Manual
Thank you for buying this Pioneer product. Please read through
these instructions so you will know how to operate your model
properly. After you have finished reading the instructions, keep
this document in a safe place for future reference.
Be sure to disconnect the
battery before connecting the power or AV cable.
Handling precautions
• Be sure to install this product correctly according to this
instruction manual. Installation other than specified may
cause an accident or injury. In this case, Pioneer does not
take any responsibility.
• When installing this product, also read the "Safety
Precautions" for the compatible Dash Camera to which this
product is to be installed.
Important safeguards
WARNING
• Any obstruction of or other interference with the airbag,
either deployed or non-deployed, or with the clear view of
the road must be avoided and, accordingly, professional
installation is required.
• Do not allow this product to come into contact with liquids.
Electrical shock could result. Also, damage to the product,
smoke, and overheating could result from contact with
liquids.
• Do not disassemble or modify this product, as there are
high-voltage components inside which may cause an
electric shock. Be sure to consult your dealer or the nearest
authorised Pioneer Service Station for internal inspection,
adjustments or repairs.
• Do not use this product in locations subjected to high
temperatures of 60°C or higher, low temperatures of –10°C
or lower, or high humidity.
English
terminal of the vehicle's
Precautions before connecting the system
CAUTION
• Secure all wiring with cable clamps or electrical tape. Do
not allow any bare wiring to remain exposed.
• Make sure that the cables and wires will not interfere with
or become caught in any of the vehicle's moving parts,
especially the steering wheel, gearstick, handbrake, sliding
seat tracks, doors, or any of the vehicle's controls.
• Do not route wires where they will be exposed to high
temperatures. If the insulation heats up, wires may become
damaged, resulting in a short circuit or malfunction and
permanent damage to the product.
• Do not shorten any cables. If you do, the protection circuit
(fuse holder, fuse resistor or filter, etc.) may fail to work
properly.
• Never feed power to other electronic products by cutting
the insulation of the power supply cable of this product
and tapping into the cable. The current capacity of the
cable will be exceeded, causing overheating.
To prevent damage
WARNING
• When replacing the fuse, be sure to only use a fuse of the
rating prescribed on this product.
Precautions before installation (I)
CAUTION
• Never install this product in places where, or in a manner
that:
- Could injure the driver or passengers if the vehicle stops
suddenly.
- May interfere with the driver's operation of the vehicle,
such as on the floor in front of the driver's seat, or close to
the steering wheel or gearstick.
• To ensure proper installation, be sure to use the supplied
parts in the manner specified. If any parts are not supplied
with this product, use compatible parts in the manner
specified after you have the parts' compatibility checked
by your dealer. If parts other than supplied or compatible
ones are used, they may damage internal parts of this
product or they may work loose and the product may
become detached.