Page 2
The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version of this Manual at the Hikvision website (https://www.hikvision.com/).
Chapter 1 Overview Introduction DS-K3G201 series is stamped and formed by sus304 stainless steel plate, beautiful in appearance, sturdy and durable, not easy to be damaged by external force, can be connected with card reader, face recognition terminal, etc., dedicated to the entrance and exit of the construction site.
DS-K3G201 Series Tripod Turnstile User Manual Main structure The product structure is shown in the figure below. The turnstile is mainly composed of mechanical parts and electronic control parts. A card reader space and direction indicator space are reserved on the top of the box. The main components of the movement are rod-falling electromagnets, telescopic electromagnets, frame, drive shaft, three-roll turnstile roller, etc.
DS-K3G201 Series Tripod Turnstile User Manual The electronic control part is composed of a card reader, a main board, a direction indicator board, a leakage circuit breaker, etc. Card reader Read the card number information, send the read information to the access controller and verify the access control authority.
DS-K3G201 Series Tripod Turnstile User Manual Chapter 2 Installation Install pedestals Before You Start Prepare for the installation tools, check the device and the accessories, and clear the installation base. The installation position of the turnstile is installed on the right, which is convenient for the right hand to swipe the card to move forward.
DS-K3G201 Series Tripod Turnstile User Manual The device should be installed on the concrete surface or other non-flammable surfaces. No face recognition terminal installed: If the installation area is too close to the wall, make sure the distance between the pedestal and the wall should be more than 50 mm, or the surface may...
DS-K3G201 Series Tripod Turnstile User Manual The size of the expansion screw should be M12. The length of the expansion screw should not be less than 120mm. It is recommended to use the expansion screw with a length of 120mm.
DS-K3G201 Series Tripod Turnstile User Manual Chapter 3 General Wiring Wiring Electric Supply The turnstile supports wiring the AC electric supply for the whole system's power supply. The voltage fluctuation of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
Page 11
DS-K3G201 Series Tripod Turnstile User Manual The place marked by the red box is the external relay output signal connection. No distinction between positive and negative wiring.
DS-K3G201 Series Tripod Turnstile User Manual Main Board Description Interface Description Power in DC 24V power supply ZERO/VCC/GND Arm position detection, when triggered the Magnet magnetic recovered, arm locked. OP_L/COM Entrance direction open OP_R/COM Exit direction open VCC/GND DC 12V power out...
DS-K3G201 Series Tripod Turnstile User Manual For example: to change the operation time of the turnstile opening time. Press the [MENU] key to enter the system menu, use the [INC] and [DEC] keys to scroll up and down to select the "F**" menu.
Page 15
DS-K3G201 Series Tripod Turnstile User Manual F-06 system initialization 0. Exit 1. Initialize the system F-07 Press menu in this interface to exit the setting mode and return to the initial interface...
DS-K3G201 Series Tripod Turnstile User Manual Chapter 5 Maintenance The main element of the turnstile is stainless steel, which is rustless (antioxidant) and corrosion resistant (The anti corrosion ability in the medium of acid, alkali, and salt). In order to keep the stainless steel from being oxidized or corroded, you should clean and care the turnstile surface periodically .