Table of Contents
Advertisement
Technical description
11.19.9 How to change the operating parameters
The setup menu can be used to change the dryer's operating parameters.
Only qualified personnel must be allowed to access to the setup menu. The manufacturer is not
responsible for malfunctioning or failure due to modification to the operating parameters.
With dryer ON simultaneously press buttons
Access to the menu is confirmed by message
Set
Keep
pressed to display the value of the selected parameter and use arrows
change the value. Release the button
Press
+
automatically).
ID
Ton – drain time ON : time ON condensate drain valve
ON = Electronic drainer installed
ToF - drain time OFF : pause time for condensate drain
valve
HdS – High DewPoint Setting : Alarm threshold for a high
DewPoint (the alarm disappears when the temperature drop
1°C / 2°F below alarm point)
Hdd - High DewPoint Delay : high DewPoint alarm enable
delay
SrV - Service Setting: setting of service warning timer.
00 = service warning timer disabled.
SrC – Service Contact : configuration of the alarm dry
contact for the service warning timer.
YES = activate the contact
contact
SCL - Scale: display scale of temperatures and pressure (°C
= temperatures in °C and pressure in barg; °F =
temperatures in °F and pressure in psig)
36
Set
+
on the display (first parameter of menu).
Set
to confirm the value and skip to following parameter.
to exit setup menu (if no button is pressed after 2 minutes the menu is exited
Description
/ NO = NOT activate the
for at least 5 seconds to enter the setup menu.
Limits
Resolution
ON
00 ... 20 sec
1 ... 20 min
0.0...25.0 °C
or
32 ... 77 °F
01 ... 20
minutes
00.0 ... 20.0
(x 1000) hours
YES / NO
°C ... °F
DRYPOINT® RS 25-1010 HP50
and
to
Standard
setup
1 sec
2
1 min
1
0.5 °C
20
or
or
1 °F
68
1 min
15
0.5
08.0
(x1000)
hours
-
YES
-
°C
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
