Installing The Fuel Tank; Installing The Muffler; Setting Up The Hydro Linkage - Toro 30524 Operator's Manual

Installing the Fuel Tank

1. Apply retaining adhesive, such as Loctite RC 609 or
680, to the threads of the 2 threaded studs (5/16 x
7/8"in.) supplied in loose parts. Install studs into the
two left holes in underside of fuel tank
2. Align the fuel tank to the top of the rear frame, and
secure the right side of the fuel tank with 2 bolts (5/16 x
3/4 in.), 2 lock washers (5/16 in.), and 2 washers
(5/16 in.) (Fig. 13).
3
2
1
Figure 13
1. Bolt , 5/8 x 7/8 in. (2)
2. Lock washer, 5/16 in. (2)
3. Washer, 5/16 in. (2)
3. Secure the fuel tank studs to the frame with 2 washers
(5/16 in.), 2 springs, and 2 locknuts (5/16 in.) (Fig. 13).
Note: Tighten the left side of the fuel tank until it is
completely tight, then unscrew the locknut one full turn.
This allows the spring to work.
4. Push the fuel line onto the fuel tank fitting, and secure
the fuel line with a hose clamp (Fig. 14).
3
2
Figure 14
1. Fuel line
2. Hose clamp
4
3
5
6
m–3771
4. Stud (2)
5. Spring (2)
6. Locknut (2)
1
m–3778
3. Fuel fitting
17

Installing the Muffler

1. Loosen the clamp (Fig. 15).
1
Figure 15
1. Muffler
2. Clamp
2. Rotate the muffler forward into the position shown in
Figure 15.
3. Secure the muffler bracket (Fig. 15) to the engine
bracket with the hardware provided.
4. Tighten the clamp.

Setting up the Hydro Linkage

Perform the following adjustments when the machine is
first set up and when any adjustment is needed. Do them in
the order that they are listed here.
Adjusting the Speed Control Linkage
Refer to Adjusting the Speed Control Linkages on page 37.
Adjusting the Neutral Control Linkages
Refer to Adjusting the Neutral Control Linkages on
page 38.
Adjusting the Hydro Control Linkages
Refer to Adjusting the Hydro Control Linkages on page 39.
Adjusting the Control Rods
Refer to Adjusting the Control Rods on page 40.
3
2
m–5941
3. Muffler bracket