Return The Extender To Its Factory Default Settings - NETGEAR WN2000RPTv3 User Manual

Return the Extender to Its Factory Default Settings

Under some circumstances (for example, if you lose track of the changes that you made to
the extender settings), you might want to erase the configuration and reset the extender to
factory default settings.
To reset the extender to factory default settings, you can either use the Restore Factory
Settings button on the rear panel or log in to the extender and reset it.
For a list of factory default settings, see

To use the Restore Factory Settings button to return the extender to factory default
settings:
CAUTION:
This process erases any settings that you configured in the extender.
1. Insert a straightened paper clip into the hole of the Restore Factory Settings button
and hold it for about seven seconds.
2. Release the button.
CAUTION:
Do not try to go online, turn off the extender, shut down the computer, or
do anything else to the extender until it finishes restarting!
The extender resets and restarts. This process takes about one minute.
N300 WiF Range Extender
Factory Default Settings
Restore Factory Settings button
Maintain and Monitor the Extender
37
on page 45.