LG LRE30451 Service page 19

REMOVING THE SURF
REMOVING THE SURF
AND THE CERAMIC GLASS COOKT
AND THE CERAMIC GLASS COOKT
!
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electrical
shock.
CERAMIC GLASS COOKTOP REMOVAL
Step. 1
Unplug the cord or disconnect power
Step. 2
Open oven door and
remove the 3screws located
at the front of the cook-top,
then close the door.
Step. 3
Lift up the cooktop front and
Remove the ground screw
securing ground wire
Step. 4
Slightly lift up and pull up the
cook-top and then unplug
the 2 connectors at the back
by squeezing side tabs
COMPONENT ACCESS
3 Screws
Ground Screws
2 Connectors
ACE ELEMENTS
ACE ELEMENTS
Step. 5
Protect the cooktop surface
and turn the assembly over.
Step. 6
To remove the surface elements
a) Remove the wires from
the element and limiter
terminals.
b) Remove the element
bracket screw (shown
above) for the element
you are servicing.
d) Carefully lift the bottom of the bracket just far enough
to remove the element.
REASSEMBLY NOTE: When you reinstall the element
make sure that the wires are inserted into the correct
tap then reinstall the bracket screw to secure it to the
cooktop.
3-4
OP
OP
Bracket screws