Ghost (3); Ghost (4); Satins On The Face Of Page - Samsung ML-1430 Service Manual

Troubleshooting

4.2.11 Ghost (3)

4.2.11 Ghost (3)
• Description • Description White ghost occurs in the black image printing at 32mm intervals. White ghost occurs in the black image printing at 32mm intervals.
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer

4.2.12 Ghost (4)

• Description Ghost occurs at 47mm intervals.
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer

4.2.13 Satins on the Face of Page

• Description The background on the face of the printed page is stained.
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
4-10
Check and Cause Check and Cause
1. The life of the developer may be expired. 1. The life of the developer may be expired.
2. The abnormal voltage and bad contact of 2. The abnormal voltage and bad contact of
the terminal of the supply roller. the terminal of the supply roller
Check and Cause
The temperature of the fuser is maintained
high.
Check and Cause
1. Toner leakage due to improperly sealed
developer.
2. If the transfer roller is contaminated, satins
on the face of page will occur.
Solution Solution
1. Occur in the developer cartridge, replace 1. Occur in the developer cartridge, replace
the developer and try to print out. the developer and try to print out.
2. Check the approved voltage of the supply 2. Check the approved voltage of the supply
roller and contact of the terminal and adjust roller and contact of the terminal and adjust
if necessary. if necessary.
Solution
1. Disassemble the fuser and remove the
contaminated toner particles on the roller
and clean the foreign matter between
Thermistor and Heat roller.
( Caution: can be deformed)
Solution
1. Replace the developer cartridge.
2. If the transfer roller is contaminated, run PC
Cleaning Mode Print 2 or 3 times.
And perform Self-Test 2 or 3 times to
remove contamination.
Samsung Electronics