Table of Contents
Advertisement
Turning On the Appliance
Starting a cycle wash
1
Draw out the lower and up per basket, load the dish es a nd push them back.
It is commended to lo ad the lower basket first, then the upper o ne (s ee the section e ntitled
"
Loading the Dishwashe r ).
2
Pour in the d etergent (see the section entitled Salt, Detergent and Rinse Aid ).
3
Insert the plug in to the socket. The power supply is 220-240 VAC /50 HZ , the specification of the
socket is 10A 25 0VAC. Make sure that the wa ter supply is turned on to full pressure.
4
Ope n the doo r, p ress the ON/OFF button, and the ON/OFF light will turn on.
Press the progra m button to a sired wash cycle. and close th e d oor . After 3 seconds, the machine will work.
Change the Program...
Premise:
1. A cycle that is underway can only be modified if it has on ly been running
for a short time. Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergen t dispenser must be refilled (see the s ection entitled " Loading the
Detergent " ).
2. Pre ss current prog. Button more tha n 3 seconds to cancel the program ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . . " ).
3. Pre ss one of others prog. Button more than 3 seconds to cancel the runing program ,
translase the program which you press.
4. Pre ss the display button more tha n 3 seconds to re-edit disp lay time .
Forgot to Add a Dish?
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working,you can open the door
completely.
At the End of the Wash Cycle
When the wo rking cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, the n stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unlo ading th e dishwasher to avoid ha ndling the dishes and utensils while they
are still hot and more susceptible to break age. They will also d ry better.
Switch Off the Dishwasher
Th e buzzer of the dishwasher moos for 8 secon ds, o nly in this ca se the programme has ended .
1.Switch o ff the dishwasher by pressing the ON/OFF bu tton.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be a llowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwas her's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet insid e.
Empty the lower basket first and then the upper one. This will avoid water dripping fro m the upper Bas ket onto
the dishes in the lower one.
WARNING!
"
It is dangerous to open the door when washing, because the hot water may scald you.
"
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
13
"
Advertisement
Table of Contents
