GE JSP34 Use And Care Manual page 25

How to Set Oven for Cleaning
Easy Reference:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycle, the word "OFF" will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1. Follow the directions in the Before a Clean
Cycle section.
2. After closing the door, press the AUTO
AUTO SELF
SELF CLEAN pad.
CLEAN
3. Press the INCREASE or DECREASE
pad until the desired Clean Time is
displayed.
Clean Time is normally 3 hours. You can
change the Clean Time to any time between
2 and 4 hours, depending on the amount of
soil in your oven.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
CLEAR
OFF
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean cycle
is set. The words "ON" and "LOCK" will appear in the
display when the door automatically locks. It will not
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off.
4. When the LOCK light is off, open the door.
NOTE:
• You can find out when the clean cycle
will be finished by pressing the STOP
STOP
TIME TIME pad.
• The word "clean" will be displayed, the word
"DOOR" will flash and oven control will signal
if you set the clean cycle and forget to close the
oven door.
• A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run after the oven is turned off.
2. When the LOCK light goes off, indicating that the
oven has cooled below the locking temperature,
open the door.
(continued next page)
25