General Maintenance; Replacing The Air Filter - AEG BAC218E Original Instructions Manual

Table of Contents

Advertisement

WARNING
Always wear eye protection with side shields. Failure to do so
could result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents
and may be damaged by their use. Use clean cloths to remove dirt,
dust, oil, grease, etc.
WARNING
products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastics which
could result in serious personal injury.

REPLACING THE AIR FILTER

See Figure 7.
Grasp the tabs on the air filter cover and pull away from the
housing.
Remove the air filter.
Install new air filter.
Replace the air filter cover by pushing it into the housing until
it clicks into place.
STORING THE AIR COMPRESSOR
Place the Auto On/Off switch in the off position.
Remove battery packs.
Disconnect air hose and air tool from the product.
Drain air tanks according to instructions.
Thoroughly clean air compressor and any accessories.
Hoses may be stored using the strap on the top of the air
compressor.
Do not modify this product in any way or use accessories not
approved by the manufacturer. Your safety and that of others may
be compromised.
Remove the battery packs before making adjustments or when
doing any maintenance on the machine.
WARNING
For greater safety and reliability, all repairs should be performed
by an authorised AEG service centre.
Use only AEG accessories and spare parts. Should components
need to be replaced which have not been described, please contact
one of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the product can be ordered. Please
state the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
10
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel no. 0800 234 797
New Zealand
SYMBOLS
Safety alert
Please read the instructions carefully before
starting the machine.
Always wear goggles when using the machine.
Wear ear protectors.
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Caution, risk of electric shock
Wet condition alert. Do not expose to rain. Store
indoors.
Risk of bursting. Do not adjust regulator to result
in output pressure greater than marked maximum
pressure of attachment. Do not use at pressure
greater than 8 bar.
Hot surface: To reduce the risk of injury or damage,
avoid contact with any surface.
Risk of breathing. Air obtained directly from the air
compressor should never be used to supply air for
human consumption.
This compressor may start without warning.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the end of
their life must be collected separately and returned
to an environmentally compatible recycling facility.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

6230329

Table of Contents