Makita XOB01 Instruction Manual page 6

1
003326
After emptying the dust bag, install the dust nozzle on
the dust bag. Turn the dust nozzle slightly clockwise to
lock it in place. Then install the dust bag on the tool as
described in "Installing dust bag".
Installing paper filter bag (Optional accessory)
009094
Make sure that the logo on the cardboard lip and the
logo on the dust box are on the same side, then install
the paper filter bag by fitting the cardboard lip in the
groove of each holding tab.
009095
Make sure that the logo on the cardboard lip and the
logo on the dust nozzle are on the same side, then
install the dust nozzle on the dust box.
Removing dust box and paper filter bag
2
1
009092
Remove the dust nozzle by pushing the two latches.
1. Dust nozzle
1. Holding tab
1
1. Dust box
2. Dust nozzle
1
2
1. Latch
2. Dust nozzle
009093
Remove the paper filter bag first by pinching the logo side of
its cardboard lip, then by pulling the cardboard lip downwards
to move it out of the holding tab of the dust box.
Removing and reinstalling the skirt
CAUTION:
Do not use the tool without the skirt. Otherwise dust is
scattered all over.
012881
You can choose one of 12 directions of the skirt in
accordance with your purpose.
1
012885
To remove the skirt, remove the screw and remove the
skirt with slightly opening it for both sides.
012945
To reinstall the skirt, install it with slightly opening it for
both sides. And fasten the screw.
6
1. Skirt
2. Screw
2
1. Skirt
1