Using Compactflash Memory Cards; Removing A Memory Card; Using A Pcmcia Adapter; Installing A Memory Card - Epson PhotoPC 600 Manual

EPSON PhotoPC 600
4. Open the connector cover on the side of the camera.
5. Depending on the type of cable you have, line up either the
arrow or the flat side of the cable connector with the mark
on the camera's serial port. Then insert the connector.
6. Turn on the camera and your Macintosh system.

Using CompactFlash Memory Cards

You can use optional ATA-compatible CompactFlash memory
cards (4MB and up) to increase the storage capacity of your
PhotoPC 600 camera. When you install a card, the camera
stores pictures on the card, rather than in its internal memory.
You can copy photos from your camera to the card (and vice
versa).
If your desktop or laptop computer has a Type II PCMCIA
card slot, you can access images on memory cards directly by
using the optional PCMCIA adapter.
CompactFlash cards increase the camera's picture storage
capacity as shown in the table below. Each card adds the
number of pictures shown to the number of pictures in the
camera's internal memory.
Number of pictures (minimum capacity)
Internal
Image Quality Memory
Standard 50
Fine 16
Super Fine 7
Fine Panorama 33
Super Fine 14
Panorama

Installing a Memory Card

Before you start, make sure the camera and the LCD screen
are turned off.
Insert the card all the way into the memory card slot, as shown
below:
8 - EPSON PhotoPC 600
4MB 8MB 12MB 16MB
Card Card Card Card
58 119 179 240
19 39 59 80
8 17 25 34
39 79 119 160
16 34 51 68
The number of pictures you can store in the memory card
appears in brackets on the camera's display panel.

Removing a Memory Card

Make sure the camera and the LCD screen are turned off.
Then follow these steps:
1. Slide the switch on the bottom of the camera to eject the
memory card.
2
2. Remove the card by hand.
CAUTION
Never remove the card while the camera is accessing it. Data in the
card may be lost or damaged. Avoid using or storing the card in dusty
places, in direct sunlight, or in places that become extremely hot or
humid.

Using a PCMCIA Adapter

Follow these steps to use an adapter:
1. Insert the memory card all the way into the adapter, as
shown below:
2. Insert the adapter into your computer's Type II PCMCIA
slot:
8/97
1