Makita BL1815N Technical Information page 15

W
iring diagram
Fig. D-5
Guide Lead wire (red) of Upper dead point
detection switch to DC motor while passing
the wire between boss A and lead wire
holder A.
Fix lead wire (black) of ON-OFF switch
with lead wire holder A.
Pass the following lead wires between rib
and inner wall of Housing L.
*Lead wire (orange) for connecting
ON-OFF switch with terminal
*Lead wire (orange) for connecting
Switch for LED circuit with Terminal
*Lead wire (red) for connecting
LED circuit with Switch for LED circuit
*Lead wire (red) for connecting
Start point regulator and DC motor
See Fig. D-6.
Terminal
See Fig. D-7.
Fig. D-6
Lead wire holder B
Lead wire (red) of
Upper dead point
detection switch
Pile lead wire (red) of Upper dead point detection switch
on LED lead wire (red), and then pass these lead wires
between lead wire holder B and the wall of Housing L.
Lead wire (red)
to + Terminal of
DC motor
Lead wire
holder A
Lead wire
holder A
LED circuit
LED lead wire (red)
[It is thinner than
Lead wire (red) of
Upper dead point
detection switch.]
Wall of Housing L
Switch put under ON-OFF Switch
Boss A
(for Upper dead point detection)
Lead wire (black) for connecting ON-OFF switch
and Upper dead point detection switch
Switch (for ON-OFF) put on
Upper dead point detection switch
Light switch arm
Switch for LED circuit
Rib
Lead wire holder B
DC motor
Fig. D-7
to Terminal
Lead wires (red and black) of LED circuit pass
between Rib A and Rib B so as not to put them
on the LED circuit.
P 15/ 15
Switch (for ON-OFF)
See Fig. D-5.
to Switch for
LED circuit
Rib B
Rib A
LED circuit