Epson PowerLite 6100i Quick Setup

C
onnect the projector
to your notebook
1
Locate the required cables:
Power cord VGA computer cable
2
C onnect the computer cable to
the blue Computer1 port
on the projector.
3
Connect the other end to your notebook's video-out
or monitor port.
NOTE: If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer's documentation).
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.
T
urn on your equipment
1
T urn on your notebook.
2
M ake sure the projector's
Power light is orange
and not flashing.
3
Press the Power button
to turn on the projector.
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice.
2. W hen the Power light is steady orange, you can unplug the
projector.
W ith Epson's exclusive Instant Off
period, so you can pack up and go immediately after turning off
the projector.
CAUTION: Never unplug the projector when the
green or flashing orange.
Power
light
Power
button
TM technology there's no cool-down
Power light is
Epson
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User's Guide.
A
djust the image
1
I f you've turned on your notebook and you don't see an image, press
the Source Search button on the projector to select the image source.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
O pen the lens access door.
3
T urn the focus ring to
sharpen the image.
Turn the zoom ring to
reduce or enlarge
the image.
4
I f your image looks like
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
I f your image looks like
on the projector to correct it.
Turn over
PowerLite 6100i
® ®
Quick Setup
or , you've placed the projector off
or , press the or buttons
Focus
Zoom