Connections Setup; Wan - D-Link DSL-G2452GR User Manual

DSL-G2452GR MU-MIMO Wireless Dual Band VDSL2 Router with
ASDL2+/3G/LTE/Gigabit Ethernet WAN Support, 2 FXS Ports and USB Port
User Manual

Connections Setup

In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).

WAN

On the Connections Setup / WAN page, you can create and edit connections used by the router.
By default, Ethernet, VDSL, and ADSL connections of the Dynamic IPv4 type are configured in
the system. They are assigned to the WAN and DSL ports of the router correspondingly. You can
edit these connections or delete them.
!
Please reboot the router after creating, editing, or removing an ADSL WAN connection.
Figure 52. The Connections Setup / WAN page. The advanced mode.
To create a new connection, click the ADD button (
that the connection creation page opens.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, on the Basic tab, the mandatory settings of this WAN connection will
be displayed. To view all available settings of the WAN connection, go to the All Settings tab.
Change the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button (
connection on the editing page.
) in the Connections List section. Upon
Page 70 of 262
Configuring via Web-based Interface
). Also you can remove a