Table of Contents
Advertisement
16/24
PSM | Installation
Bosch Rexroth AG, RE 95190-B/2021-08-12
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the product (contains the permissible technical data,
main dimensions and circuit diagrams of standard versions)
7�1 Unpacking
NOTICE! Danger due to electrostatic discharge!
When unpacking the sensor, there is a danger of damage to the electronic
components of the sensor due to electrostatic discharge.
▶ During unpacking, the sensor is to be protected against electrostatic discharge.
▶ Remove the packaging from the sensor.
▶ Check the sensor for transport damage and completeness, see chapter 4
"Scope of delivery" on page 12.
▶ Dispose of the packaging in accordance with the regulations in your country.
7�2 Installation conditions
The installation position and position of the sensor essentially determine the
procedures for installation and commissioning.
▶ Do not install the sensor close to parts that generate considerable heat
(e.g. exhaust).
▶ Lines are to be routed with sufficient distance from hot or moving vehicle parts.
▶ A sufficient distance to radio systems must be maintained.
▶ Before electric welding and painting operations, the sensor must be disconnected
from the power supply and the sensor connector must be removed.
▶ Cables/wires must be sealed individually to prevent water from entering
the sensor.
7�3 Installing the spool position sensor
7�3�1 Preparation
1� Use the material number on the sticker of the packaging unit or directly on the
sensor housing to check whether the correct sensor is available, see chapter 4
"Scope of delivery" on page 12.
2� Compare the material number with the details in the order confirmation.
If the material number of the sensor does not match the one in the order
confirmation, contact your local contact person for clarification. You can find
their contact information at
https://addresses.boschrexroth.com
Advertisement
Table of Contents
