Honeywell NOTIFIER SFP-10UD Series Manual page 93

Master Programming Level
CENTRAL STATION
1=COMM FORMAT
2=EVENT CODES
Primary/Secondary Screen #3
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C2 1/24/2012
Enter the digits as you would like the number to be dialed. For example, if it's necessary to dial 9
before dialing a number outside the building, you may wish to pause after dialing 9. Enter 9 fol-
lowed by D for a three second pause, or E for a five second pause then the phone number followed
by an F to indicate the end of the number.
Communication Format
Pressing 1 while viewing Primary/Secondary Screen #3 will cause the following screen to be dis-
played:
1=ADEMCO CONTACT ID
2=SIA-DCS-8
3=SIA-DCS-20
The Communication Format is determined by the type of receiver that the DACT is transmitting to.
Consult your Central Station for proper selection or consult our factory representatives. For any
format chosen, the control panel automatically programs all of the event codes.
Select the Communication Format by pressing the corresponding number key while viewing the
Comm Format screen. The following table describes each format:
Screen Selection
ADEMCO CONTACT ID
SIA-DCS-8
SIA-DCS-20
Event Codes
Pressing 2 while viewing Primary/Secondary Screen #3 will cause the following screen to be dis-
played:
1=ZONE 1 ALARM
2=ZONE 2 ALARM
3=ZONE 3 ALARM
Pressing the down arrow key allows viewing of all Events associated with the selected Communi-
cation Format. Pressing the number corresponding to the event displayed in each screen will dis-
play its default active and restoral event codes which can be customized by the programmer.
For example, if Ademco Contact ID is the selected format, pressing 3 for Zone 3 Alarm will display
the following screen which allows the Event Code to be changed from the default value.
ZONE 3 ACTIVE
COMM FORMAT
Communication Format Description
Contact ID, DTMF, 1400/2300 ACK
Security Industry Association, 8 messages per call
Security Industry Association, 20 messages per call
Table 3.2 Communication Formats
EVENT CODES
Event Code Screen
115
Programming
93