Printing And Copying Problems - Epson Artisan 730 Quick Manual

Epson artisan 730: user guide

Hide thumbs Also See for Artisan 730:

Quick setup instructions (4 pages)

Specifications (2 pages)

Service manual (327 pages)

Table of Contents

WiFi light is on but you can't print

■

Your router might not be assigning IP addresses automatically using DHCP. If it isn't,

you will need to set the product's IP address manually. Make sure it is set correctly for

your network. Contact your router manufacturer for assistance.

■

Make sure your firewall or security software is not set to block port 3629 (TCP/

UDP). Contact your firewall manufacturer for assistance.

Printing is slow or the print is cut off

Print a Network Status Sheet (see below) and check the signal strength. If it's poor, try

moving the product closer to your wireless router or access point. Avoid placing the

product next to a microwave oven, 2.4 GHz cordless phone, or large metal objects such as

a filing cabinet.

Cannot scan over the network

■

Epson Scan is not available in Mac OS X 10.6; see page 17 for scanning instructions.

■

If you cannot scan from the product's touch panel, make sure you restarted your

computer after installing the product software. Make sure Epson Event Manager is

not being blocked by your firewall or security software.

■

If you are scanning a large document at high resolution, a communication error may

occur. If the scan did not complete, lower the resolution.

■

If network communication was interrupted while starting Epson Scan, exit Epson

Scan, and restart it after a few seconds. If Epson Scan cannot restart, turn the product

off and on, and then try again. Check the

. For details, see the Epson Scan Help.

Settings

Print a Network Status Sheet

Press

Press u or d to select

Press x

Start