Craftsman CMCD701 Installation Manual page 10

English
Fig. C
Trigger Switch & Forward/Reverse Button
(Fig. D)
• The drill is turned ON and OFF by pulling and releasing
the trigger switch 1 . The farther the trigger is
depressed, the higher the speed of the drill.
• A forward/reverse control button
rotational direction of the tool and also serves as a lock
off button.
• To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
• To select reverse, depress the forward/reverse control
button on the left side of the tool.
• The center position of the control button locks the tool
in the off position. When changing the position of the
control button, be sure the trigger is released.
Fig. D
1
Adjusting Torque Control (Fig. A)
This tool is fitted with a torque adjustment collar
the operating mode and to set the torque for tightening
screws. Large screws and hard workpiece materials
require a higher torque setting than small screws and soft
workpiece materials.
8
Speed Selector (Fig. E, F)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
•
•
nOTE: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the speed
selector is either completely pushed forward or completely
9
pushed back.
Fig. E
2 determines the
Fig. F
2
LED Work Light (Fig. A)

When drill driver is activated by pulling the trigger
switch
3 to select
automatically illuminate the work area.
nOTE: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
away from the chuck.
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
CAUTION: Do not stare into worklight. Serious eye
injury could result.
1 , the integrated LED work light
4
4
4
8 will