Advertisement

L7WB86GW
USER
MANUAL
EN
User Manual
Washer Dryer

Advertisement

Table of Contents
loading

Summary of Contents for AEG L7WB86GW

  • Page 1 L7WB86GW User Manual Washer Dryer USER MANUAL...
  • Page 2: Table Of Contents

    19. ACCESSORIES......................41 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
  • Page 4 Do not install the appliance behind a lockable door, a • sliding door or a door with a hinge on the opposite side, that would prevent the appliance door from being fully opened. Connect the mains plug to the mains socket only at •...
  • Page 5: Safety Instructions

    ENGLISH removers should be washed separately with an extra amount of detergent before being dried in the washer dryer. Do not use the appliance if items have been soiled • with industrial chemicals. Do not dry unwashed items in the wash dryer. •...
  • Page 6 2.4 Use • The floor area where the appliance is to be installed must be flat, stable, heat resistant and clean. WARNING! • Keep the transit bolts in a safe place. Risk of injury, electrical If the appliance is to be moved in...
  • Page 7: Installation

    ENGLISH 3. INSTALLATION 4. Open the door and remove the WARNING! polystyrene piece from the door seal Refer to Safety chapters. and all the items from the drum. 3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance.
  • Page 8 We recommend that you 9. Remove the power supply cable and keep the packaging and the the drain hose from the hose holders. transit bolts for any movement of the appliance. It is possible to see 3.2 Positioning and levelling water flowing from the drain hose.
  • Page 9 ENGLISH 4. Connect the water inlet hose to the A correct adjustment of the cold water tap with 3/4" thread. appliance level prevents the vibration, noise and the movement of the appliance when in operation. When the machine is installed on a plinth or if a washer dryer is stacked on the washing machine, use the accessories described in...
  • Page 10 You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide.
  • Page 11: Product Description

    ENGLISH 6. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 4. PRODUCT DESCRIPTION 4.1 Appliance overview 11 12 Worktop Drain hose Detergent dispenser Inlet hose connection Control panel Mains cable Door handle Transit bolts...
  • Page 12: Control Panel

    5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Option touch button (Vlekken/ Voorwas) Display Delay Start touch button (Startuitstel) Drying time touch button (Tijd) Time Saving touch button (Tijd Drying level touch button besparen) (Droogtegraad) Spin reduction touch button (TPM)
  • Page 13 ENGLISH Maximum laundry indicator. It flashes when the laundry load exceeds the maximum declared load of the selected programme. If you run a programme when the drum is overloaded, also flashes at the end of the programme. Drying time indicator. Door locked indicator.
  • Page 14: Dial And Buttons

    6. DIAL AND BUTTONS 6.1 Introduction 6.5 TPM When you set a programme, the When pressing a key appliance automatically sets the combination, do not tilt maximum spin speed allowed. your fingers downwards . The sensors of the Touch repeatedly this button to: underneath buttons are •...
  • Page 15: Programmes

    ENGLISH 6.7 Startuitstel You cannot set all time values for different types of With this option you can delay the start fabrics. of a programme in a more convenient time. 6.10 Droogtegraad Tap on the button repeatedly to set the required delay.
  • Page 16 Programme Programme description White cotton and coloured cotton. Normal soil and light soil. Cottons energy saving programme. This programme at 60ºC Katoen Eco with a load of 8 kg is the reference programme for data en- tered in the energy label, in compliance with EEC 92/75 stand- ards.
  • Page 17 ENGLISH Programme Programme description Steam programmes Stoom Steam can be used for dried, washed or worn once laun- dry. These programmes can reduce creases and odours and make your laundry softer. Do not use any detergent. If necessary, remove stains by washing or using localized stain removal.
  • Page 18 Programme Default tempera- Maximum spin speed Maximum load ture Spin speed range Temperature range 40 °C 1200 rpm 3 kg 40 °C - Cold 1200 rpm - 400 rpm Fijne was 40 °C 1200 rpm 1.5 kg 40 °C - Cold...
  • Page 19 ENGLISH Options Tijd bespa- ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Startuitstel ■ ■ ■ ■ ■ ■ Tijd ■ Droogtegraad ■ 1) If you set No Spin option, the appliance only drains the water. 2) This option is not available with temperature lower than 40 °C.
  • Page 20 7.3 Automatic drying Dryness Level Type of fabric Load Cottons and Linen up to 4 kg (bathrobes, bath towels, etc) Extra Dry For towelling materials Cottons and Linen up to 4 kg (bathrobes, bath towels, etc) Cupboard Dry For items to be stored...
  • Page 21: Settings

    ENGLISH Dryness Level Type of fabric Load Spin Sugges- (kg) speed ted du- (rpm) ration (mins) Cupboard Dry Cottons and Linen 1600 170 - 190 For items to be (bathrobes, bath towels, etc) 1600 80 - 100 stored 1600 50 - 60 Synthetics and mixed fabrics 1200 130 - 145...
  • Page 22: Before First Use

    If you deactivate the the display. acoustic signals, they • Simultaneously touch the Temp. continue operate when the button and the TPM button twice to appliance has a malfunction. add two extra rinses.
  • Page 23 ENGLISH 10.4 Check the position of the CAUTION! flap Make sure that no laundry stays between the seal and 1. Pull out the detergent dispenser until the door. There is a risk of it stops. water leakage or damage to 2.
  • Page 24 With the flap in the To perform washing only, position DOWN: make sure that only the • Do not use Wassen indicator is on gelatinous or thick above the Modus button. liquid detergents. • Do not put more In case a selection is not...
  • Page 25 ENGLISH Changing the delay start after this case, it will be not possible to guarantee the best washing results. the countdown has started About 20 minutes after the To change the delay start: programme start, the 1. Touch the Start/Pauze button to programme duration could pause the appliance.
  • Page 26 10.11 Cancelling a running 10.13 End of the programme programme When the programme has finished, the appliance stops automatically. The 1. Press the button Aan/Uit to cancel acoustic signals operate (if they are the programme and to deactivate active).
  • Page 27: Daily Use - Washing & Drying

    ENGLISH If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. 11. DAILY USE - WASHING & DRYING 11.2 Washing and Drying - WARNING! Automatic levels Refer to Safety chapters.
  • Page 28: Daily Use - Drying Only

    • In the display comes on. indicator comes on. • The indicator of button Start/Pauze Each time you tap on this button the goes off. The door locked goes time value increases by 5 minutes. The display shows the set new time value.
  • Page 29: Fluff In The Fabrics

    ENGLISH The display also shows the remaining To have a good drying by programme time. using less energy and in a shorter time, the appliance 12.4 At the end of the drying does not let you set a too programme low spin speed for the items to be washed and dried.
  • Page 30: Hints And Tips

    14. HINTS AND TIPS Special stain removers are available. Use WARNING! the special stain remover that is Refer to Safety chapters. applicable to the type of stain and fabric. 14.1 The laundry load 14.3 Detergents and other treatments • Divide the laundry into: white, coloured, synthetics, delicates and •...
  • Page 31: Care And Cleaning

    ENGLISH 14.5 Water hardness • = The item can be tumble dried • = The drying cycle is at high If the water hardness in your area is high temperature or moderate, we recommend that you use a water softener for washing •...
  • Page 32 15.1 External cleaning 15.4 Door seal Clean the appliance with mild soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Regularly examine the seal and remove Do not clean the metal all objects from the inner part.
  • Page 33 ENGLISH 2. Remove the top part of the additive 15.7 Cleaning the drain pump compartment to aid cleaning and flush it out under running warm WARNING! water, to remove any traces of Disconnect the mains plug accumulated detergent. After from the mains socket. cleaning, replace the top part in its position.
  • Page 34 6. Repeat the steps 4 and 5 until the water stops to flow out. 7. Turn the filter anti-clockwise to remove it. 2. Place a suitable bowl below the drain pump access to collect the water that flows out.
  • Page 35 ENGLISH 12. Close the pump cover. 2. Remove the inlet hose from the appliance by loosening the ring nut. When you drain the water with the emergency drain procedure, you must 3. Clean the valve filter on the back of activate the drain system again: the appliance with a toothbrush.
  • Page 36: Troubleshooting

    15.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
  • Page 37 ENGLISH The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Authorised Service Centre. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre.
  • Page 38 Problem Possible solution • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Make sure that the drain filter is not clogged. Clean the fil- ter, if necessary. Refer to "Care and cleaning".
  • Page 39 ENGLISH Problem Possible solution Too much foam in the • Reduce the quantity of detergent. drum during the washing cycle. After the washing cycle, • Make sure that the flap is in the correct position (UP for there are some deter- powder detergent - DOWN for liquid detergent).
  • Page 40: Consumption Values

    4. Pull twice the emergency unlock 5. Take out the laundry and then close trigger downward and open the the appliance door. appliance door. 6. Close the filter flap. 17. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards.
  • Page 41: Technical Data

    19.1 Available in 19.3 Pedestal with the drawer www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. 19.2 Fixing plate kit...
  • Page 42 20. ENVIRONMENTAL CONCERNS appliances marked with the symbol Recycle materials with the symbol with the household waste. Return the Put the packaging in relevant containers product to your local recycling facility or to recycle it. Help protect the contact your municipal office.
  • Page 43 ENGLISH...
  • Page 44 www.aeg.com/shop...

Table of Contents