Wall-Mounting The Front And Surround Speaker System; Resetting The Main Unit; Cleaning The Unit - Pioneer HTP-075 Operating Instructions Manual

6
6
Wall-mounting the front and surround speaker
system
Attaching the brackets
• When attaching the speakers to brackets, always use the
furnished brackets for wall mounting.
• Make sure to tighten the supplied screw as securely as
possible when attaching the bracket to the back of the
speaker.
• Do not attach brackets to center speaker or subwoofer.
CAUTION
• Use the M5 metric thread screw. Do not use inch thread
screw.
Before mounting
• Remember that the speaker system is heavy and that its
weight could cause the wood screws to work loose, or the
wall material to fail to support it, resulting in the speaker
falling. Make sure that the wall on which you intend to
mount the speakers is strong enough to support them. Do
not mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker. If
you are unsure of the qualities and strength of the walls,
consult a professional for advice.
Screw (supplied)
3 9
5 mm to 7 mm ( /16 in. to /32 in.)
Mounting screw (not supplied)
37

Resetting the main unit

Use this procedure to reset all the receiver's settings to the
factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down BAND, press and hold
5 mm
ÍSTANDBY/ON
3
( /16 in.) 3
When you see RESET? appear in the display, press
10 mm
7
AUTO SURROUND/STREAM
( /16 in.)
OK? shows in the display.
4
Press
ALC/STANDARD SURR
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Important
• If the Standby Through is not set to OFF, you may not be
able to initialize the unit.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the surface is dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water,
and wrung out well, and then wipe again with a dry cloth.
Do not use furniture wax or cleansers.
• Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode the
surface.
Additional information
for about two seconds.
DIRECT.
to confirm.
2
4
34