Advertisement
16
16A
16A
16 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (16A) to Faucet Inlets (16B). (Supply lines and
fi ttings are not included). Please follow manufacturer's instructions when
installing supply lines.
POP-UP DRAIN BODY INSTALLATION STEPS
17
17L
17A
17A
17G
17J
17H
17E
17B
17 POP-UP PREPARATION
Remove Flange (17A) and unscrew Nut (17C) from the Pop-Up Drain Body
(17B). Retain the Packing Ring (17D) inside the Ball Rod Opening (17E). Take
off the Spring Clip (17F) from the Ball Rod (
17F
17F) from the Ball Rod (
Ball Rod (17G). Remove Locknut (17H), Friction Washer (17J), Rubber Washer
(17K) and Stopper (
17K) and Stopper (
17L) from Flange (17A).
17K
16B
17F
17C
17K
17G
17D
17C
17E). Take
17E
17G). Place the Nut (17C) on the
17J
17J), Rubber Washer
ENGLISH
18
18D
18E
18F
18 POP-UP INSTALLATION
Apply a small bead of putty underneath the Flange (18A) and place a ring of
putty around Drain Opening (18B) of sink. Use PTFE plumber's tape to all
threaded fi ttings according to manufacturer's instructions. Insert Flange (18A)
into Drain Opening (18B). From underneath, insert Rubber Washer (18C) and
Friction Washer (18D) through the bottom of Flange (18A). Thread Locknut
(18E) until Rubber Washer (
18E) until Rubber Washer (
18E
Thread Drain Body (18F) to bottom of Flange (
Drain Body so that the Ball Rod Opening (18G) faces the rear. Wrench tighten
Locknut (18E) and wipe excess putty.
18E) and wipe excess putty.
18E
19
19C
19 BALL ROD ADJUSTMENT
Drop the Stopper (19A) into Drain Body (19B) from the top with the Off-Set (19C)
facing rear. From below, insert the Ball Rod (19D) into the Ball Rod Opening
(19E) through the Stopper Hole (
19E) through the Stopper Hole (
19E
5
18A
18A
18B
18C
18G
18C) seats securely inside Drain Opening (18B).
18F) to bottom of Flange (
18F
18A). Hand tighten and adjust the
19A
19A
19F
19E
19B
19D
19F) and secure with Nut (
19F) and secure with Nut (
19F
19D
19G
19G).
Advertisement
