Table of Contents
Advertisement
Monitoring and Controlling
i
If the password screen is displayed, enter the password you set in
step 3 for Remote Camera Access - Password, and then press
OK.
A message is displayed on the projected image, and shooting starts.
It takes approximately six seconds to acquire the image.
a
• Adjust the exposure as necessary. If you make any
adjustments, shoot again and check the adjusted image.
• When shooting, you cannot perform any operations except for
turning off the projector.
• You cannot shoot warning or caution messages.
Using the Mail Notification Function to Report
Problems
When you set Mail Notification, notification messages are sent to the preset
email addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Network - Notifications - Mail Notification
s
a
• Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.
• If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
• If you set Standby Mode to Communication On, you can control
the projector even if it is in standby mode (when the power is
off).
s Extended - Standby Mode
p.154
p.142
Reading error notification mail
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Sender: The email address set in From
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.
• Clean Air Filter (Air Filter Notice)
• Constant brightness expired (Constant Bright. End)
• Internal error (Internal Error)
• Fan related error (Fan Error)
• Sensor error (Sensor Error)
• Laser error (Laser Error)
• Laser warning (Laser Warning)
• Retardation Plate Error (Retardation Plate Error)
• Internal temperature error (High Temp Error/Overheating)
• High-speed cooling in progress (High Temp Warning)
• Low Air Flow (Low Air Flow)
• Low Air Flow Error (Filter Airflow Error)
222
Advertisement
Table of Contents
