Installation Of Motor In Vehicle - ABB AMXE132 Manual

MoTor InsTAllATIon In vEhIClE

4.1.3. Installation of motor in vehicle

For dimensions involving the motor's flange and side support, see the outline drawing. The product code
is visible on the rating plate, see Figure 2.
For side support mounting, see Figure 1. There are threaded M10 holes located on the D-end and the ND-
end at 3, 6 and 9 o´clock. To ensure that the structure is not damaged, the alignment between the side
support and the mating surfaces must be accurate. The figure below illustrates the max. allowed height
difference between the D-end and ND-end. To achieve this, shims between the side support and the
mating surfaces can be used.
ND-end
Figure 8. Max allowed height difference between D-end and ND-end.
Recommended tightening torques can be seen in Table 4.
Thread size
M6
M8
M10
M12
M16
Table 4. Recommended tightening torques.
NOTE: It is advisable to apply thread locking (Loctite 243 or similar) when installing the motor.
D-end
Grade 8.8
10,3 Nm ±5%
25 Nm ±5%
49 Nm ±5%
85 Nm ±5%
206 Nm ±5%
17