Basic Operation; Notes On Using The Lcd Panel; Adjusting The Lcd Panel Angle; Resetting The Microprocessor - Pioneer AVH-Z9190BT Owner's Manual

RETURN Press to return to the specified point and start playback from there.
Press to pause or resume playback.
or For audio: Press and hold to perform fast reverse or fast forwards.
For video: Press to perform fast reverse or fast forwards.
or Press to return to the previous track (chapter) or go to the next track (chapter).
Press to answer or end a call.
Press to stop playback.
If you resume playback, playback will start from the point where you stopped.
Press the button again to stop playback completely.
FOLDER/P.CH Press to select the next or previous title or folder.
Press to recall radio station frequencies assigned to preset channel keys.
Press to answer or end a call.

Basic operation

Notes on using the LCD panel

WARNING
• Keep hands and fingers clear of this product when opening, closing, or adjusting the LCD panel. Be
especially cautious of children's hands and fingers.
• Do not use with the LCD panel left open. It may result in injury in the event of an accident.
CAUTION
• Do not open or close the LCD panel forcefully. It may cause a malfunction.
• Do not operate this product until the LCD panel has completely opened or closed. If this product is
operated while the LCD panel is opening or closing, the LCD panel may stop at that angle for safety.
• Do not place glass or can on the open LCD panel.

Adjusting the LCD panel angle

1
Press .
2
Touch or to adjust the angle of the LCD panel.
3
Touch .
Returns to the previous screen.

Resetting the microprocessor

CAUTION
• Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
• The microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
1
Turn the ignition switch OFF.
2
Press RESET with a pen tip or other pointed tools.
Settings and recorded contents are reset to the factory settings.
7
En