Summary of Contents for Land METEK SYSTEM 4
- Page 1 Landmark Graphic Processor I/O Card Installation Guide Issue 3 30 November 2016 Publication Nº 198.245 Language: English © Land Instruments International, 2016...
-
Page 2: Health And Safety Information
Observe precautions for handling electrostatic discharge sensitive devices. Equipment Operation Use of this instrument in a manner not specified by Land Instruments International may be hazardous. Read and understand the user documentation supplied before installing and operating the equipment. The safety of any system incorporating this equipment is the responsibility of the assembler. - Page 3 Design and Manufacturing Standards The Quality Management System of Land Instruments International is approved to BS EN ISO 9001 for the design, manufacture and on-site servicing of combustion, environmental monitoring and non-contact temperature measuring instrumentation.
- Page 4 Landmark Graphic Processor I/O Card Installation Guide...
- Page 5 Installation Guide Landmark Graphic Processor I/O Card Contents Introduction Description Installation Instructions Contents...
- Page 6 Landmark Graphic Processor I/O Card Installation Guide LANDMARK GRAPHIC ® LMG 1 1 1994 S/NO. 123/456/78 MADE IN ENGLAND RS 485 200 - 240V 100 - 120V RS 232C 35VA MAX. T 1A 250V 50-60Hz I/O Card Fig. 1 Location of I/O Card andscrews on back panel...
- Page 7 Installation Guide Landmark Graphic Processor I/O Card Introduction The information contained in this Installation Guide describes the procedures necessary to either fit a new I/O Card or replace an existing I/O Card. Description An Input/Output (I/O) card serves as a hardware interface between: •...
- Page 8 Landmark Graphic Processor I/O Card Installation Guide It should be noted that there are a number of different I/O cards available from Land for LMG processors or Application-Dedicated processors based on LMG. Card ID Nº Description Compatibility S4 I/O Card System 4 &...
-
Page 9: Installation Instructions
Installation Guide Landmark Graphic Processor I/O Card Installation Instructions This section must be referred to when installing or removing an I/O Card. Warning Risk of electric shock. Disconnect the processor from the a.c. mains power supply before removing the rear panel. Caution Observe precautions for handling electrostatic discharge sensitive devices. - Page 10 Landmark Graphic Processor I/O Card Installation Guide Page 4...
-
Page 11: Product Warranty
We believe that our customers expect us to set the standard in terms of performance, quality, reliability and value for money. This 36 months warranty, as a part of an on-going program of continuous improvement, is just one way in which Land strive to maintain our position as the temperature measurement partner of choice. -
Page 12: Exclusions From Warranty
It should be noted that costs associated with calibration checks which may be requested during the warranty period are not covered within the warranty. Land reserve the right to charge for service/calibration checks undertaken during the warranty period if the cause is deemed to fall outside the terms of the warranty.