Table of Contents
Advertisement
and possible injury.
Ensure that the fan is switched off from the supply mains before
removing the guar.
WARNING
If unusual oscillating movement is observed, immediately stop
using the fan and contact the manufacturer, its service agent or
suitably qualified persons.
The replacement of parts of the safety suspension system device
shall be performed by the manufacturer, its service agent or suitably
qualified persons.
The fixing means for attachment to the ceiling such as hooks or
other devices shall be fixed with a sufficient strength to withstand 4
times the weight of the fan.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING! To reduce the risk of fire, personal injury, and
product damage due to a short circuit, never immerse your tool,
battery pack or charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater, certain industrial
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
ASSEMBLY
WARNING
Do not use this product if it is not completely assembled or if any
parts appear to be missing or damaged. Use of a product that
is not properly and completely assembled or with damaged or
missing parts could result in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or
attachments not recommended for use with this product. Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.
OPERATION
WARNING
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING
Do not use any attachments or accessories not recommended
by the manufacturer of this tool. The use of attachments or
accessories not recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purpose listed below:
■
General ventilation of most household spaces.
This product is designed to be powered by either a 18V battery pack
(DC mode) or by electric power (AC mode). Either power source
can be used by installing an approved battery pack or power cord
into the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 1.
■
Turn the control knob to the OFF (0) position.
■
Open the battery cover.
6
■
Insert the battery pack into the product as shown.
■
Make sure the latches on each side of the battery pack snap
into place and the battery pack is secured before beginning
operation.
■
Depress the latches to remove the battery pack.
■
Close the battery cover.
Always remove battery pack or unplug extension cord from your
product when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack or
unplugging extension cord will prevent accidental starting that
could cause serious personal injury.
NOTE: The battery pack should be recharged after approximately
5 hours of use to reduce the possibility of damage. Repeated deep
discharge of the battery may decrease storage capacity and battery
life.
INSTALLING/REMOVING POWER CORD
See Figure 2.
■
Turn the control knob to the OFF (0) position.
■
Open the battery cover.
■
Insert the female end of the power cord into the product as
shown.
■
Connect the male end of the power cord to the power source.
■
Make sure the power cord is secured before beginning
operation.
STARTING/STOPPING THE PORTABLE FAN
See Figure 3.
■
Connect the portable fan to a power cord or approved battery
pack.
■
Turn the control knob clockwise to turn the portable fan ON and
to adjust fan speed.
■
To stop the portable fan, turn the control knob counterclockwise
to the OFF (0) position.
Hybrid tools are always in operating condition. Therefore, the
control knob should always be in the OFF (0) position when not
in use and the power source is removed.
CHANGING PORTABLE FAN SPEED
See Figure 3.
■
For low speeds, rotate the control knob clockwise.
■
For high speeds, rotate the control knob counterclockwise.
HANGING/MOUNTING PORTABLE FAN
See Figures 4 – 10.
Your portable fan has a variety of hanging options. Choose the
option that is best suited for your location.
NOTE: The portable fan can be hung in a vertical or horizontal
position. Be careful not to hang the fan in such a way that it prevents
normal fan operation or damages the cord.
Hanging the fan using the key hole:
■
Place the wide portion of the key hole over the head of a screw.
■
Slide the portable fan down until the screw is inside the narrow
portion of the key hole and the fan is secure.
Hanging the fan using the hooks:
■
Pull the hooks completely out of their slots and rotate them as
needed.
6
WARNING
WARNING
■
Mo
■
■
■
■
Mo
■
Mo
■
■
AD
See
The
pos
BA
Bat
rech
Tem
of th
(risk
The
For
afte
To
from
For
•
•
•
TR
Lith
Leg
Tra
loca
■
■
Wh
■
■
Advertisement
Table of Contents
