Controls - GE ADTK15 Owner's Manual

About the controls on the portable room heater.
Features and
appearance
may vary.
HI
heat on

Controls

Power Pad
On the remote control, press to turn
the heater on. It will turn on in the standby
mode, and the display will show the room
temperature. (Use the Mode pad on the remote
control to set to HI heat, LO heat or fan mode.)
Press again to turn the heater off.
On the unit, press the Power pad to turn
the heater on (it will turn on in the standby
mode and the display will show the room
temperature), set to HI heat, LO heat, fan mode
and to turn the heater off. Press again to turn
the heater off.
Display
Shows the room temperature. Flashes the set
temperature while setting the temperature in
LO or HI heat modes. Shows whether set in
LO heat, HI heat or fan mode. Shows time
remaining on timer.
NOTE: The display will change to show the
room temperature after settings have been
made. To recall the set temperature, press
the Increase (+) or Decrease (–) pads.
Increase (+) Pad
Use to increase the set temperature
(when in the heat mode) or to increase
the shut-off time.
Decrease (–) Pad
Use to decrease the set temperature
(when in the heat mode) or to decrease
the shut-off time.
Heat Mode
When in the HI or LO heat mode, use the Increase (+)/
Decrease (–) pads to set the desired temperature
between 40°F and 90°F in 1°F increments.
Fan Mode
Use the fan mode to provide air circulation
without heating.
LO
heat on
Portable Heater Control
Fan
only on
Timer
on
Temperature
is displayed
in degrees
Fahrenheit.
OSC/Oscillate Pad
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn on until
the desired air direction is obtained; then turn
it off.
Timer Pad
When the heater is on, it can be set to
automatically turn off in 1/2 (0.5) to 9
hours.
1. Press the Timer pad. The display will blink.
2. Press the + or – pad to set the desired time
for the unit to stop. (Each time you touch
the + or – pad, the set time will advance
by 1/2 hour between 0 and 9
After settings have been made, the display
will change back to show the room
temperature.
To cancel the timer, press the Timer pad
and press the Decrease (–) pad until 0.0
appears in the display.
NOTE: If the Timer was set before a power
outage, it will need to be reset after power
is restored.
Mode Pad
Press to set to HI heat, LO heat, fan mode or
to return to the standby mode.
A thermostat is used to maintain the room
temperature. The heater will cycle on and off to
keep the room at the set level of comfort. Set the
thermostat at a higher temperature and the indoor
air will become warmer. Set the thermostat at a
lower temperature and the indoor air will become
less warm.
Since the fan setting does not provide heating,
a temperature setting will not be displayed.
Remote Control
(on some models)
(on some models)
(on some models)
⁄ (9.5)
1
2
1 ⁄ hours.)
2
(on the remote control only)
ge.com
3