Removal And Replacement Procedures - Acer AB2x280 F1 Service Manual

Removal and replacement procedures

Required tools
You need the following items for some procedures:
T-10/T-15 Torx screwdriver (included with the server)
•
Preparation procedures
To access some components and perform certain service procedures, you must perform one or more of the
following procedures:
Extend the server from the rack
•
If you are performing service procedures in the rack cabinet, you can use the locking feature of
the rack rails to support the server and gain access to internal components.
For more information about telco rack solutions, refer to the RackSolutions.com website
Power down the server
•
If you must remove a server from a rack or a non-hot-plug component from a server, power down
the server.
Remove the server from the rack
•
If the rack environment, cabling configuration, or the server location in the rack creates awkward
conditions, remove the server from the rack.
Access the product rear panel
•
If you are performing certain service procedures, access the product rear panel.
Chapter 2
Chapter 2
9