Installation Recommendation - RIDGID MT-HS23P User Manual

RIGID HVAC CO., LTD * info@rigidhvac.com * https://www.rigidchill.com * https://www.rigidhvac.com
3.2.3 Installation Position Selection
Choose the place where is flat and able to support the weight of the unit.You can add some mounting
brackets if necessary.
Please try to install the cooler closes to car roof, make for air circulation.
Plus, install the cooler and condenser closely to make the pipeline as short as possible.
The cooler is better to be installed in the position where is good for air in&out.

Installation Recommendation:

Top of Co - pilot/Back top of cab
Condenser should be installed in the position where will not influence the air in and heat air out.
Position Recommendation
Back of Cab- needs to confirm if the cab can support the weight of the condenser.
Frame behind driver's cab- longer connecting pipeline needs to be reserved for cab up and down.
The air inlet size of cooler and condenser should be more than 10cm
The air outlet of condenser must be at least 30cm.
3.2.4 Cooler Installation
Confirm the installation position according to the wiring connection requirements
Fix the wall board according to the cooler installation position and pipe connection.
Please make sure there is at least 4 fixed points between wall board and cab.
The places where the holes are punched must be consulted with the car manufacturer in advance,to
make sure it will not influence the car's circuit,structure and function.
Also the cooler must be mounted horizontally.
3.2.5 The condenser Installation
Confirm the installation position according to the wiring connection requirements
If install the condenser on the back of cab, please make sure there is at least 10 fixed points.