Power Connector Cable - HP 15-bs0 Series Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the display (see
To remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Remove the cable from its routing path in the computer (2).
3. Use a tool to pry the connector out of the computer (3), and then remove the power connector cable (4).
Reverse this procedure to install the power connector cable.
82 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 34).
Optical drive on page
Bottom cover on page
Display assembly on page
35), if installed.
45).
72).
Spare part number
931613-001