Table of Contents
Advertisement
Installation
Connecting the Antenna Cable to the RF In Terminal
Antenna Connection - For proper reception of VHF/
UHF channels, an external antenna is required. For
best reception an outdoor antenna is recommended.
Antenna Mode must be set to TV.
VHF Antenna
UHF Antenna
Mixer
75 Ohm Coaxial Cable
Antenna / Cable Connection
Incoming Cable From Home Antenna (75 Ohm) / Incoming 75 Ohm Cable (From Cable Company)
VHF/UHF
Antenna Connection (Cable Box, no VCR)
Use this configuration when connecting the TV to a cable TV system using a Cable Box.
8
Using the Cable Cover
1. Installing the cable clamp.
2. Using the Cable Clamp
Open the cable clamp
and pass the antenna
cable through.
3. Connect the antenna cable to RF in terminal.
4. Installing the Cable Cover
RF in Terminal
Coaxial
Antenna Plug
Clamper
Removing the Cable Cover
Cable Connection - For reception of cable channels (01 - 125) connect the
cable supplied by your local cable company. Antenna Mode must be set to
CABLE. (Refer to Antenna Mode section.)
Note:
Certain cable systems offset some channels to reduce interference or have
Premium (scrambled) channels. A cable converter box is required for proper
reception. Check with your local Cable company for its compatibility requirements.
ANTENNA
TERMINAL ON
THE LEFT SIDE
OF THE TV
Connect the cable from the Output
terminal on the back of the Cable
Box to the ANT terminal on the left
side of the TV.
Claw
Insert the 2 upper claws into the
mating slots.
Press in the bottom section of the
cover.
Release the 2 lower claws from their
slots.
Slowly pull the cover downward.
CABLE BOX
OUTPUT
INPUT
TERMINAL ON THE BACK
OF THE CABLE BOX
Incoming Cable from
Antenna or Cable TV
System
Coaxial
cable
Advertisement
Table of Contents
