9.18 Dismantling the chain brake sensor
1
Dismantle the drive wheel cover, saw chain and
bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Unplug the connector (A).
See figure 40.
3
Dismantle the chain brake.
See "Dismantling the chain brake".
4
Remove the chain brake sensor.
See figure 41.
Cleaning and inspection
• Clean and check the sensor. The sensor must
always be replaced with a new one if cracked
or showing signs of other defects. Always use
original spare parts.
See figure 42.
9.19 Assembling the chain brake sensor
1
Place the sensor in the crankcase.
See figure 43.
2
Assemble the chain brake.
See "Assembling the chain brake".
3
Plug in connector (A) and place it in its attachment
on the chain brake cover.
See figure 44.
4
Assemble the saw.
Refer to "Basic dismantle/assembly".
A
Fig 40
Fig 41
Fig 42
Fig 43
A
Fig 44
Repair Instructions
39
English –