Assembly - Husqvarna 966805003 Owner's Manual

BAGGER SUPPORT ASSEMBLY
1. Slide the flanges of the support assembly in the
slots in the drawbar.
Support Assembly
2. Pivot the assembly backwards to insert the bottom
pin into the drawbar. Secure the bottom pin with a
hairpin.
Hairpin

ASSEMBLY

Drawbar
DECK ADJUSTMENT
1. Locate the rear adjustment nut on the discharge
side of the deck. To assure the right tighteness,
mark the front side of the nut.
2. Using the mark as a guide, turn the nut clockwise
2½ turns with a ¾" wrench.
MOUNTING BLOWER ASSEMBLY
1. Remove the discharge chute from the deck.
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Position blower over the discharge tabs on the deck
and set blower onto the deck.
5. Be sure the blower is sitting flush against the
outside of the deck.
Rear Mount Bracket
Contact Area
5