Summary of Contents for Daken DK120
- Page 1 Finishing Mower DK120, DK150, DK180 Operators Manual & Parts List Clark Equipment P/L 30 Salisbury Road Hornsby NSW 2077 Phone Toll Free 1800 636 451...
-
Page 2: Additional Information And Potential Changes
1. Introduction Your Daken Finishing Mower has been designed to do a range of work to your satisfaction. This list of instructions covers the basic requirements for safety and maintenance and will ensure good service if carried out as directed. - Page 3 This information is important in the proper use of your machine. Failure to follow this instruction could result in damage to your machine or property. THINK Safety! WORK Safely! Please read the following safety information carefully and follow the advice given to avoid any potential dangers to yourself and others or damage to the machine.
-
Page 4: Specifications
3. Specifications Your Daken Finishing Mower is designed to cut a variety of grasses and other ground covers. You take the responsibility if the machine is used for any other purpose. The Finishing Mower consists of three rotating shafts with five three steel blades attached to them. The blades cut the grass while travelling over the working area. - Page 5 Machine Running-in Although there are no operational restrictions on the Finishing Mower, when used for the first time, it is recommended that the following mechanical checks be made: A. After operating for ½ hour or after completing 2 acres: 1. Check and tighten all nuts, bolts and other fasteners. 2.
-
Page 6: Field Operation
Routine Service and Maintenance The Daken Finishing Mower is designed to cut grass on a finished surface. It is a simple and reliable system that requires minimal maintenance. However, to prolong the life of your Finishing Mower, it is important and recommended to carry out regular service and maintenance. -
Page 7: Troubleshooting
C. Maintenance Daily Maintenance: Check and tighten all nuts, bolts and connection parts. Check the oil in the gearbox. Fill it up to dedicated line if necessary. Press grease in each nipple three to five times. Clean the mower; remove all grass, mud and debris. Seasonal Maintenance: Check the machine as for Daily Maintenance. -
Page 8: Parts Illustration
6. Parts Illustration The following section contains a parts list for your machine. When ordering parts for your Finishing Mower, always give your dealer the Model and Serial number of your machine. This will assist him in ordering and obtaining the correct parts. Use the exploded view and parts list of the area of interest to exactly identify the required part.