Manual Configuration; Ethernet Converter Manager - Buffalo AirStation Turbo G High Power WLI-TX4-G54HP Quick Setup Manual

Manual Configuration

If your wireless router/access point doesn't support AOSS, you'll
need to configure the access point manually. There are two ways
to do this: you can use the Ethernet Converter Manager software
if you have a Windows PC on the network (98/ME/2000/XP only),
or you may use a web browser. Web browser configuration may be
done with any computer running a recent web browser, including
Macintosh and Linux machines (Skip to page 7 for web based config).

Ethernet Converter Manager

If you have a Windows 98/ME/2000/XP machine with a CD-ROM
drive available on your computer network, the Ethernet Converter
Manager makes it simple to configure the Ethernet Converter. The
following steps will guide you through configuring the Ethernet
Converter via the Ethernet Converter Manager.
•
Connect one of the Ethernet Converter's LAN ports to an open
port on your network's router, switch or hub with the included
network patch cable. If there are no ports available, you can
temporarily remove a computer or other connected device and plug
the Ethernet Converter to that port. You can plug the Ethernet
Converter directly to the configuring computer, but will have to
configure settings manually as described on page 8.
•
Once the network cable has been plugged in, plug the Ethernet
Converter's AC Adapter into an available power outlet. Then
attach the power connector to the back of the Ethernet Converter.
The boot up process takes 30 seconds and is complete when both
the Wireless and Ethernet LEDs are lit.
•
Return to the PC designated for configuration and insert the
included Ethernet Converter CD-ROM into the PC's CD-ROM drive.
•
The Ethernet Converter Utility should launch automatically. If
it does not, browse your CD-ROM drive in Windows and run the
setup.exe program.