Installation; Mounting To The Wall - Buffalo Power Over Ethernet Receiver WLE-POE-R33 Quick Setup Manual

Mounting to the Wall Mount Kit
■ NOTE: It is recommend to remove the Wall Mount Kit from the wall first.
◗ Mount the attachment to the Wall Mount Kit as show in the following diagram.
◗ Align the attachment screw holes (for mounting this product) with the screw
holes on the rear panel of the POE Receiver, and secure with the 5mm screws.
◗ With the POE Receiver attached to the Wall Mount Kit, mount the Wall Mount
Kit to the wall.

Mounting to the Wall

◗ Make two holes in the wall at the same distance apart as the mounting holes
on the attachment bracket, and then mount the 16mm screws.
◗ Align the attachment screw holes (for mounting the product) with the screw
holes on the rear panel of the POE Receiver, and secure with the 5mm screws.
◗ Suspend the attachment screw holes from the screws mounted to the wall.
Standing on the Floor or Table
◗ Affix the rubber feet provided in the product package to the indentations on the
bottom panel of the POE receiver and then stand the product on the floor or table.
Attachment
Attachment holes
Screw holes (for WLE-POE-R7/R33)
AirStation
WLE-WK
Screws (12mm)
Screw holes (for WLE-WK)
2

Installation