Buffalo GC882 Operating Instructions

Please read and keep
the instruction
GC882 and GC883 Aluminium Heat Shades
OPERATING INSTRUCTIONS
INTRODUCTION
1. Read the instructions before using the appliance.
2. Clean Heat Shade thoroughly before and after each use following the cleaning
instructions provided in this manual.
ELECTRICAL REQUIREMENTS
This product should only be connected to the mains electricity supply by a qualified electrician. Hardwire the
Heat Shade into a suitable power supply with correct voltage and sufficient power capacity. Refer to the
product label (serial plate) on the warmer for voltage and wattage requirements.
SAFETY INSTRUCTIONS
1. All power must be disconnected at power source before any service procedure is performed.
2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep
combustible materials, such as drapes and other furnishings, away from appliance.
3. Extreme caution is necessary when any appliance is used by or near children and whenever the
appliance is left unattended.
4. Always disconnect appliance before cleaning, maintaining and adjusting it.
5. Do not operate any appliance with a damaged cord or plug if the appliance malfunctions or has been
dropped / damaged. Return appliance to an authorised service facility for examination, electrical or
mechanical adjustment, or repair.
6. Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance
where it may fall into water.
7. Avoid the use of extension cords. Do not run cord under carpeting, runners, or the like. Arrange cord away
from traffic area and where it will not create a trip hazard.
8. This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are
used or stored.
9. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
10. If the supply cord is damaged, it must be replaced by the manufacturer, it's service agent or similarly
qualified persons in order to avoid a hazard
WARNING!
This unit only suitable for R40 or BR40 type incandescent lamps.
The lamp is excluded from the warranty.
Buffalo Telephone Helpline:- 0845 146 2887 (United Kingdom)
PREPARATION
1. Remove the Heat Shade assembly from the carton.
2. Remove tape and protective packaging from all surfaces of unit.
3. Make sure the installation site provides the proper installation
clearances for the unit
indoor use only. Don't discard