Advertisement
2.
IntroductIon
i
mobile induction heater for fast heat delivery. Install appropriate coil and place over or around ferrous metal. Ideal for loosening stubborn
and seized fixings. Supplied with pad coil for plastic trim/sticker removal. Induction element delivers high heat fast and effectively.
Supplied in carry-case.
3.
SpecIFIcatIon
i
model no .................................................................... VS240
Supply ............................................................................230V
Frequency .................................................................50/60Hz
Power ..........................................................................1000W
duty Cycle .............................2 minutes on - 5 minutes oFF
net weight ..................................................................... 1.7kg
fig.1
4. operatIon
4.1.
WorK cYcLe - two minutes on, 5 minutes off.
4.2.
note: do not use the induction heater longer than for one work cycle. The circuit board has overheating protection but
the electrodes do not.
4.3.
dIrect coIL/SIde coIL
4.3.1.
Coil to heat nuts/bolts, screws etc. fig.2. Keep gap of 3-4mm between coil and object being heated. do not reuse bolts as heat may
have effected the physical properties of the bolt.
4.4.
pad coIL Ø55MM
4.4.1.
Use Pad coil for heating of sheet steel to assist with the removal of decals, stickers, sealants/putties, use the coil approximately 5mm
away from the surface of the steel sheet.
WarnInG! over heating will damage painted surfaces. no liability will be accepted for damage caused by improper use.
‰
4.5.
FLeX coIL 830MM
4.5.1.
Use Flex coil when it is not possible to use direct coils due to space, or position of object to be heated. Can be used on exhaust pipes
and suspension parts, by wrapping the coil around the part before connecting to the torch.
5. MaIntenance
WarnInG! Before maintenance and any repair, the power supply must be turned off and the plug removed from the socket.
‰
5.1.
Remove dust by using clean dry compressed air regularly, if operating in a dusty environment this should be done on a daily basis.
5.2.
Check cables for any sign of damage, if any part of the heater is damaged replace or repair. If in doubt contact a qualified electrician.
5.3.
Avoid water and steam entering the machine, if this happens disconnect from power source and allow to dry, do not use unless it
has been checked by a qualified electrician.
5.4.
If not in use the machine and attachments should be stored in a dry, childproof area.
6. troubLeShootInG
6.1.
The induction heater switches itself off when it overheats, however, the electrodes do not have protection against overheating. This
is the reason for a work cycle (4.1).
6.2.
If the induction heater switches off suddenly and the LED lamp changes to blinking mode make sure that the power supply is not
interrupted. If you are using an extension cord, make sure there are no kinks in it. let the device cool down for at least 15 minutes and
then try again.
6.3.
If the problem persists, please contact your Sealey stockist.
© Jack Sealey limited
Item no.
1
2
3
4
5
fig.2
Original Language Version
description
Part no:
Ø20mm direct coil
VS2303
Ø32mm Direct coil
VS2407
Ø55mm Pad coil
VS2309
Flex coil - 830mm
VS2410
U-coil - 430mm
VS2411
VS240
Issue 3 (1, 3) 13/11/18
Advertisement
