Configuring Access Point; Connecting To Web-Based Interface - D-Link DAP-600P Quick Installation Manual

DAP-600P

CONFIGURING ACCESS POINT

Connecting to Web-based Interface

Start a web browser. In the address bar of the web browser, enter the IP
address of the access point (by default, the following IP address is specified:
192.168.0.50). Press the Enter key.
If the error " The page cannot be displayed " (or " Unable to display the
!
page "/" Could not connect to remote server ") occurs upon connecting to
the web-based interface of the access point, make sure that you have
properly connected the access point to your computer.
If the device has not been configured previously or the default settings have
been restored, after access to the web-based interface the Initial Configuration
Wizard opens (see the Initial Configuration Wizard section, page 20).
Quick Installation Guide
17