Prior To Operation - Hitachi DH 36DBL Handling Instructions Manual

NOTE
Be sure to pull out the battery from the charger after use, and then keep it.
CAUTION
○ If the battery is charged while it is heated because it has been left for a long time
in a location subject to direct sunlight or because the battery has just been used,
the charge indicator lamp of the charger lights for 1 second, does not light for 0.5
seconds (off for 0.5 seconds). In such a case, fi rst let the battery cool, then start
charging.
○ When the charge indicator lamp fl ickers (at 0.2-second intervals), check for and
take out any foreign objects in the charger's battery connector. If there are no
foreign objects, it is probable that the battery or charger is malfunctioning. Take it
to your authorized Service Center.
○ Since the built-in micro computer takes about 3 seconds to confi rm that the battery
being charged with charger is taken out, wait for a minimum of 3 seconds before
reinserting it to continue charging. If the battery is reinserted within 3 seconds, the
battery may not be properly charged.

PRIOR TO OPERATION

1. Confi rming condition of the environment
Confi rm that the work site is placed under appropriate conditions
conforming to prescribed precautions.
2. Attaching the side handle (Fig. 6)
(1) Turn the grip of the side handle to loosen it and push it in until it
comes in contact with the housing.
(2) Adjust the side handle to the angle that allows the easiest use, then
turn the side handle's grip fi rmly to lock it place.
3. Mounting the drill bit (Fig. 7, Fig. 8)
CAUTION
To prevent accidents, make sure to turn the switch
off .
NOTE
When using tools such as drill bits, etc., make sure to
use the genuine parts designated by our company.
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the tool holder
until it latches itself. (Fig. 7)
The grip need not be adjusted during bit installation.
(3) Check the latching by pulling on the drill bit.
(4) To remove the drill bit, fully pull the grip in the direction of
the arrow and pull out the drill bit. (Fig. 8)
Part of
SDS-plus
shank
Drill bit
37
English
Loosen
Fig. 6
Front
Grip
cap
Fig. 7
Drill bit
Grip
Fig. 8
Tighten